Author Topic: Replace the cage  (Read 5174 times)

Offline sandhopper2

  • Newbie
  • *
  • Posts: 44
    • View Profile
  • Your Best Time: none
  • Your Engine: vw 1915 turbo
  • Your Track: none
  • Your Vehicle: 205" RED
  • General Location: west coast
Replace the cage
« on: December 28, 2018, 09:24:29 AM »
Not sure if I can get some more room by replacing the cage , but any Idea how much it would cost ? It maybe easier to do the entire thing , but could just the front tube and the side tubes be replaced ? I'm in SOCAL

Offline THE FRENCHTOWN FLYER

  • Sr. Member
  • ****
  • Posts: 360
    • View Profile
  • Your Best Time: 8.28@168 door; 9.00@147 6-cyl alt; 8.53@160 RED
  • Your Engine: 300 Ford six NA w/ crossflow and prod. heads
  • Your Track: Milan, Thompson
  • Your Vehicle: (3) Advanced Chassis altered , The Last Logghe altered, '30 RPU
  • General Location: North Coast
Re: Replace the cage
« Reply #1 on: December 28, 2018, 07:27:41 PM »
Every bit of $400 if you're lucky.
And you remove the old cage yourself.
« Last Edit: February 02, 2019, 06:57:17 AM by THE FRENCHTOWN FLYER »

Offline Draw 3D

  • Jr. Member
  • **
  • Posts: 71
    • View Profile
  • Your Engine: Blown Alky 406 SBC
  • Your Track: Wild Horse Pass
  • Your Vehicle: 1923 T Roadster
  • General Location: Arizona
Re: Replace the cage
« Reply #2 on: December 29, 2018, 09:17:15 AM »
I just had my roll cage redone to raise it a few inches and I supplied the pre-bent tubing from Mark Williams, around $350 funny car style, and had a local chassis guy cut the old cage off and fit and welded the new cage at a specific location and the chassis guy charged me $500 and did it in 2 days.

Offline sandhopper2

  • Newbie
  • *
  • Posts: 44
    • View Profile
  • Your Best Time: none
  • Your Engine: vw 1915 turbo
  • Your Track: none
  • Your Vehicle: 205" RED
  • General Location: west coast
Re: Replace the cage
« Reply #3 on: January 06, 2019, 07:46:06 AM »
where to get some CM in socal ?

Offline Paul New

  • Hero Member
  • *****
  • Posts: 743
    • View Profile
  • Your Best Time: 6.47 @ 214 MPH SBC
  • Your Engine: 387" SBC
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: 2005 FED
Re: Replace the cage
« Reply #4 on: January 06, 2019, 09:26:18 AM »

dreracecar

  • Guest
Re: Replace the cage
« Reply #5 on: January 07, 2019, 04:26:13 PM »
Aircraft Spruce in Corona (right off the 91 at Autocenter dr.) open Sat @7am, then bring it to me for bending