hilborn shotgun injector

[wideopen231]

hilborn shotgun injector anyone have one? Need few dimensions. Need to know outside to outside   at shaft bearing bores. I have shaft ordered for new project but will take two weeks to get it and want to get head start on building injector and intake. While not a must have its a I want and not holding up anything. Just a project to do at night instead of watching fox news and letting info of stupidity in this world drive blood pressure higher,

I f happen to have shotgun injector and have shaft out for what ever reason. I would love to know distance from outer bearing surface to other.

[wideopen231]

How about center to center on butterflys? easy to figure from there.

[LZ]

Howdy wide
I can get you dims off mine. But will be tomorrow most likely

Luke

[wideopen231]

Let me know in case I can't get anyone else.I have question on another site also. Thanks

[LZ]

Wide:
So didn't think to ask for accuracy needed. So did a caliper measurment if you need closer I will need more time.
So measuring outside bore to outside bore it showed about 10.815 with the bores being 5.250 +  At 5.250 the caliper was a little loose so thus the plus say 2505. Might explain the .815.  Sooooooooo this maths 5.565 Cl to Cl.  Logic dictates nominal is 5.562 (9/16)     Didn't measure land between bores it was cold in a hurry. Would have helped conform the 5 9/16.
Is that a help? My 12 inch wasn't enough to get out side of casting boss's it was shy by like 3/8 's.
Let me know
Luke

[wideopen231]

Great. Lots quicker than Hilborn has been. I can do math as to what divider is. My spilling sucks my math rocks asking any lagging accountant I have ever met.LOL

Gives me exactly what I need to get mill fired up and have ready before shaft arrives.Might even gat adapter box done and be ready to mount.


     Thanks a lot.
                                                                                                                                                                                   Chris