Classifieds (Please No Dealers) > Wanted to buy

Front engine dragster wanted

<< < (2/2)

sawdawg:
good advice on the Fenton car, I guess I'll just have to drive around and try sitting in more cars. I sold my door car last week and at least now I have some money for this project

JrFuel Hayden:
If you are still interested in Dan Fenton's JF chassis, which of course you could change to run NE-1,2,3, or put a blown alky engine in it.
More info, 210" WB, new chassis tag, complete, less engine and trans [ PG] Roll cage width is 19 1/2, will fit at least a 6' tall, 200 lb driver
Comes with current Crow belts, Simpson chute, Safe Craft fire bottle, engine is 36" out  [ you would need to run a "shorty PowerGlide" ],
light weight 12 bolt drop out rear-end, 4.88 gears lightened & Rem polished, with spare 4.46 gears, gun drilled Strange axles, with carbon brakes,
Alum driveshaft,  titium wheel studs, Weld rear 5x5 alum wheels with 31x12x15 Goodyear slick, 17" wire spoke front wheels with Goodyear front runner tires.
Bandit shifter, CM single wheel wheelie bar
If bought new from Neil & Parks complete would be $25-30K , Ball park what Dan is looking for $12k
Best ET with NHRA Heritage JrFuel rules was 7.16 @ 185 mph
Dan Fenton, 510-398-3709

sawdawg:
I finally found a fed just a hundred miles from my house. I bought the Mccurdy and sons dragster out of West Linn Oregon. They ran a big block chevy with a blower. The car has a 210 inch wheel base. I got it as a roller now I need a bbc race engine for it. The weirdest thing is it has a 19 1/2 inch cage but I fit. I go race at Bonneville in a week so all my time is spent on that cas for now

Navigation

[0] Message Index

[*] Previous page