« previous next »
Pages: 1 [2]   Go Down

Author Topic: SBC Enderle Cover  (Read 7698 times)

Offline Roger

  • Full Member
  • ***
  • Posts: 183
    • View Profile
  • Your Vehicle: 125 inch Altered
Re: SBC Enderle Cover
« Reply #15 on: July 25, 2018, 04:40:22 PM »
One step closer to firing it up:)
Logged

Offline dusterdave173

  • Hero Member
  • *****
  • Posts: 638
    • View Profile
  • Your Best Time: 5.38in 1/8th
  • Your Engine: 355 CI SBC
  • Your Track: Mooresville, NC
  • Your Vehicle: CenPen 200 inch FED
Re: SBC Enderle Cover
« Reply #16 on: July 25, 2018, 05:11:09 PM »
I use a spacer on end of crank between the damper and the lower gear to space damer out IIRC about .200 thick range--worked perfect to get my Romac out far enough so it did not hit pump flange and that is with Enderle cover  Cheap easy to make
Logged
I have always had a fascination with fast cars at the expense of more normal character development

Offline JrFuel Hayden

  • Hero Member
  • *****
  • Posts: 600
    • View Profile
    • Hayden Enterprises Speciality Wheels
  • Your Best Time: 6.02, 236 mph, 1/4 in 1973 Div 3 TF Champ
  • Your Engine: SBC, Alky, 403 ci, Best 6.99 @ 190 & 409 Hemi
  • Your Track: Bakersfield
  • Your Vehicle: 225" FED NHRA Heritage Jr Fuel
Re: SBC Enderle Cover
« Reply #17 on: July 25, 2018, 05:12:31 PM »
I assume with that cover you are running a chain cam drive, not a belt drive.
Nice pointer,
Jon
Logged
Jon C. Hansen

Hayden Wheels

Offline opa1

  • Full Member
  • ***
  • Posts: 155
    • View Profile
  • Your Best Time: 5:60 1/8
  • Your Engine: 355 Chevy Methanol Injected
  • Your Track: Alamo City Motorplex
  • Your Vehicle: 71 Ed Mabry Jr. Fuel
  • General Location: South Coast
Re: SBC Enderle Cover
« Reply #18 on: July 25, 2018, 05:42:24 PM »
Quote from: dusterdave173 on July 25, 2018, 05:11:09 PM
I use a spacer on end of crank between the damper and the lower gear to space damer out IIRC about .200 thick range--worked perfect to get my Romac out far enough so it did not hit pump flange and that is with Enderle cover  Cheap easy to make

I bought the .150 spacer from alkydigger.  It was necessary to move the balancer out so it would clear at the oil seal. I did still have to trim the pump extension some to clear. A thicker spacer would have worked too. It's a done deal now. :)
Logged
Pages: 1 [2]   Go Up
« previous next »