Author Topic: Starting Battery Setups/Carts  (Read 7862 times)

Offline Paul New

  • Hero Member
  • *****
  • Posts: 743
    • View Profile
  • Your Best Time: 6.47 @ 214 MPH SBC
  • Your Engine: 387" SBC
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: 2005 FED
Re: Starting Battery Setups/Carts
« Reply #15 on: August 10, 2018, 09:56:06 PM »
So if you wire two twelves in series, can your ignition, water pump, etc. handle 24 volts?

A long time ago we had two small batteries mounted on our old car to create 24 volts we just hooked our accessories to one of the batteries to get 12 volts

Offline gregm784

  • Sr. Member
  • ****
  • Posts: 384
    • View Profile
    • Means Racing
  • Your Engine: 365" GenIV SBC
  • Your Track: Famoso Raceway
  • Your Vehicle: 1997 Stirling 200" FED
Re: Starting Battery Setups/Carts
« Reply #16 on: August 14, 2018, 09:08:59 AM »
MSD says their stuff is ok with 18v, but not 24v.

I run my onboard stuff off a Milwaukee M18 drill battery. 
Greg
El Dorado County, CA
www.meansracing.com

Offline JrFuel Hayden

  • Hero Member
  • *****
  • Posts: 600
    • View Profile
    • Hayden Enterprises Speciality Wheels
  • Your Best Time: 6.02, 236 mph, 1/4 in 1973 Div 3 TF Champ
  • Your Engine: SBC, Alky, 403 ci, Best 6.99 @ 190 & 409 Hemi
  • Your Track: Bakersfield
  • Your Vehicle: 225" FED NHRA Heritage Jr Fuel
Re: Starting Battery Setups/Carts
« Reply #17 on: August 21, 2018, 10:32:38 PM »
A few years ago we moved from two 12 volt car batts in the back of our truck and long cables, problem was moving the truck in place, and getting out of the way.
Then I made to two Odessy batts that we could take out of the truck.
Then I made the lightest battery paks using litheum batts that with a  alum carry case weighs 10 lbs with cables. For one reason all of our crew are close to or over 70 years old.
We have been using the Hayden light weight battey paks for 5 years.
We do run an on board 14 amp battery , that weighs one lb to power the RacePak and trans brake.
One idea I've been working with a Heritage AF team with a blown Alan Johnson Hemi is running the two Hayden batts on board that uses a hi-torque flywheel starter, that works Great, we also have another Hayden Pak to plug in if any crew forgets to keep the on board batt charged up. My idea is Heritage AF can only run Heritage races, but if the FED is self starting he could run some Top Dragster races, IE more TNT and seat time.
The point I'm making is any blown car could use this system with out the hassle of using the blower starters. Yes, the on board batt's weigh about 8 lbs total, but if you don't need to get lighter, all you'll need is a crew member with a primer bottle.
Let me know what you think,
Jon Hansen, 805-444-4489
Jon C. Hansen

Hayden Wheels