« previous next »
Pages: [1]   Go Down

Author Topic: Ride height  (Read 3381 times)

Offline gtpete

  • Newbie
  • *
  • Posts: 25
    • View Profile
  • Your Best Time: none
  • Your Engine: none
  • Your Track: Santa Pod
  • Your Vehicle: FED
  • General Location: Northamptonshire
Ride height
« on: December 26, 2018, 11:57:45 PM »
Hello. I am just about to start my FED build and would be interested to know what kind of chassis ride height a lot of you guys run ? Thanks in advance Pete.
Logged

Offline fuel749

  • Full Member
  • ***
  • Posts: 159
    • View Profile
    • Dragster Supply
  • Your Track: New England Dragway
  • Your Vehicle: FED/Altered
Re: Ride height
« Reply #1 on: December 28, 2018, 01:01:06 PM »
I set my stuff at 3 3/4
Logged

Offline THE FRENCHTOWN FLYER

  • Sr. Member
  • ****
  • Posts: 360
    • View Profile
  • Your Best Time: 8.28@168 door; 9.00@147 6-cyl alt; 8.53@160 RED
  • Your Engine: 300 Ford six NA w/ crossflow and prod. heads
  • Your Track: Milan, Thompson
  • Your Vehicle: (3) Advanced Chassis altered , The Last Logghe altered, '30 RPU
  • General Location: North Coast
Re: Ride height
« Reply #2 on: December 28, 2018, 07:26:16 PM »
My chassis guy uses 4". Even though the minimum spec is 3" It makes it a lot harder to load / offload at that height and he says the difference in e.t. is nil. Not to mention high centering it on eneven ground.
Logged

Offline gtpete

  • Newbie
  • *
  • Posts: 25
    • View Profile
  • Your Best Time: none
  • Your Engine: none
  • Your Track: Santa Pod
  • Your Vehicle: FED
  • General Location: Northamptonshire
Re: Ride height
« Reply #3 on: December 30, 2018, 11:49:44 PM »
Thanks guys for your replies. I guess I'll have more questions as the build progresses. Thanks again.
Logged

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Ride height
« Reply #4 on: December 31, 2018, 05:28:15 PM »
actaully spec is 3" front to 12" past front axle centerline and 2" minimum rest of car if I am not mistaken. I am at 3.25 front and just under 3 at motorplate. Make sure to allow for tires at race pressure.
Logged
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot
Pages: [1]   Go Up
« previous next »