« previous next »
Pages: [1]   Go Down

Author Topic: Offset Drive  (Read 2619 times)

Offline Scuzme

  • Newbie
  • *
  • Posts: 7
    • View Profile
  • Your Best Time: 7.05 1/4 mile @192mph
  • Your Engine: 407cu in sbc blown alky
  • Your Track: MereMere
  • Your Vehicle: fed nostalgia
  • General Location: Whangarei new zealand
Offset Drive
« on: July 07, 2018, 06:03:44 PM »
Hi there, I am fitting an 8/71 Blower to our sbc. I need to use an offset drive for the Mag. The mag we are running is an MSD promag lt12. I was thinking along the lines of a 3” Dunn. The problem is they have a cross drive and the Mag has a square drive with a magnetic chopper below it. Does anyone know if there are adaptors available or any other ways of adapting the mag to the drive.[/url]][url][/url]
Logged

Offline Paul New

  • Hero Member
  • *****
  • Posts: 743
    • View Profile
  • Your Best Time: 6.47 @ 214 MPH SBC
  • Your Engine: 387" SBC
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: 2005 FED
Re: Offset Drive
« Reply #1 on: July 07, 2018, 07:53:14 PM »
Does the LT12 have a band clamp mount? If so any of the SBC/BBC offset drives should work as far as the cross drive goes you can buy a cross drive to install on your mag.  Spud sales the aluminum cross driver so you can buy it from him.

http://fuelinjectionenterprises.com
Logged

Offline Scuzme

  • Newbie
  • *
  • Posts: 7
    • View Profile
  • Your Best Time: 7.05 1/4 mile @192mph
  • Your Engine: 407cu in sbc blown alky
  • Your Track: MereMere
  • Your Vehicle: fed nostalgia
  • General Location: Whangarei new zealand
Re: Offset Drive
« Reply #2 on: July 07, 2018, 09:36:43 PM »
Hi Paul, these pics might help to see my problem.
Logged

Offline Paul New

  • Hero Member
  • *****
  • Posts: 743
    • View Profile
  • Your Best Time: 6.47 @ 214 MPH SBC
  • Your Engine: 387" SBC
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: 2005 FED
Re: Offset Drive
« Reply #3 on: July 07, 2018, 10:10:50 PM »
Thanks for the pics and yes it does clear things up. That is not a band clamp mount and I am not sure if there is an adapter to mount this to any of the available offset drives.  I would call Spud Monday and talk to them.
Logged

Offline Scuzme

  • Newbie
  • *
  • Posts: 7
    • View Profile
  • Your Best Time: 7.05 1/4 mile @192mph
  • Your Engine: 407cu in sbc blown alky
  • Your Track: MereMere
  • Your Vehicle: fed nostalgia
  • General Location: Whangarei new zealand
Re: Offset Drive
« Reply #4 on: July 07, 2018, 11:33:30 PM »
It does have a clamp as can be seen in the background. I think the easiest way would be to make a new shaft for the offset drive and mount the chopper and square drive on that. I will give Spud a ring tho just to make sure there is nothing available first. Thanks anyway.
Logged
Pages: [1]   Go Up
« previous next »