« previous next »
Pages: [1]   Go Down

Author Topic: Fuel Hose Type  (Read 2198 times)

Offline opa1

  • Full Member
  • ***
  • Posts: 155
    • View Profile
  • Your Best Time: 5:60 1/8
  • Your Engine: 355 Chevy Methanol Injected
  • Your Track: Alamo City Motorplex
  • Your Vehicle: 71 Ed Mabry Jr. Fuel
  • General Location: South Coast
Fuel Hose Type
« on: June 26, 2018, 07:31:50 AM »
I'm having to run a flex type hose for my methanol fuel system. I'll be using 12AN hose from tank to pump. I can use stainless or the Phenix nylon braided hose. Is there any advantage of either? I would think the phenix would be a little lighter and somewhat more flexible. Thoughts?
Logged

Offline glofria

  • Full Member
  • ***
  • Posts: 139
    • View Profile
  • Your Best Time: 7.323 @ 185.05
  • Your Engine: A blown 388 c.i. Small Block Chevy
  • Your Track: Auto Club Famoso Raceway
  • Your Vehicle: An original 1957 Chevy Bel-Air
  • General Location: Southern California
Re: Fuel Hose Type
« Reply #1 on: June 26, 2018, 08:12:00 AM »
Should make no difference. While the nylon braided lines can be more flexible, you'll want to run them so there is no way to kink or collapse which would be devastating.

More importantly, use a Teflon lined hose. The alcohol will not dissolve the interior wall. Just be careful cutting the hose as the Teflon may distort.
Logged

Offline opa1

  • Full Member
  • ***
  • Posts: 155
    • View Profile
  • Your Best Time: 5:60 1/8
  • Your Engine: 355 Chevy Methanol Injected
  • Your Track: Alamo City Motorplex
  • Your Vehicle: 71 Ed Mabry Jr. Fuel
  • General Location: South Coast
Re: Fuel Hose Type
« Reply #2 on: June 26, 2018, 02:01:29 PM »
The Phenix hose is CPE inner core. (chlorinated polyethylene). Looks like the stainless is PTFE (polytetrafluoroethylene). I guess both will work?
Logged
Pages: [1]   Go Up
« previous next »