Technical > Matt Shaff's Engine Shop

SBC Enderle Cover

<< < (4/4)

Roger:
One step closer to firing it up:)

dusterdave173:
I use a spacer on end of crank between the damper and the lower gear to space damer out IIRC about .200 thick range--worked perfect to get my Romac out far enough so it did not hit pump flange and that is with Enderle cover  Cheap easy to make

JrFuel Hayden:
I assume with that cover you are running a chain cam drive, not a belt drive.
Nice pointer,
Jon

opa1:

--- Quote from: dusterdave173 on July 25, 2018, 05:11:09 PM ---I use a spacer on end of crank between the damper and the lower gear to space damer out IIRC about .200 thick range--worked perfect to get my Romac out far enough so it did not hit pump flange and that is with Enderle cover  Cheap easy to make

--- End quote ---

I bought the .150 spacer from alkydigger.  It was necessary to move the balancer out so it would clear at the oil seal. I did still have to trim the pump extension some to clear. A thicker spacer would have worked too. It's a done deal now. :)

Navigation

[0] Message Index

[*] Previous page