Technical > Matt Shaff's Engine Shop

SBC Enderle Cover

(1/4) > >>

opa1:
I couldn't find a Hilborn cover so I bought a SBC Enderle timing cover for cam/pump drive. I have a 6 3/4 balancer and I don't think it's going to work. Looks like I'll need to buy the 5.80 balancer. Will I also need to get a pump drive extension (2"-3") to clear the waterman pump and the fuel valves? I want to mount the primary,hi-speed returns, fuel in and shutoff direct off the pump. Looks like its going to be a tight fit.


I don't have the pump yet. Should be here by next week.

spitzerscott:
I had the same problem,  I bought a Romac balancer, they are all steel, SFI certified, and mine measures under 5.875.  Mine is part #0206 for an internally balanced SBC.   Hope this will be of help.    Right around  $150.00

opa1:

--- Quote from: spitzerscott on June 15, 2018, 01:33:27 PM ---I had the same problem,  I bought a Romac balancer, they are all steel, SFI certified, and mine measures under 5.875.  Mine is part #0206 for an internally balanced SBC.   Hope this will be of help.    Right around  $150.00

--- End quote ---

I'm looking at the Romac 5.80 that alkydigger sells. They want 229.00 Where did you find it for 150.00? Did the pump hoses clear the balancer front face, or did you need a pump extension too?  I'm using a Waterman 400 pump.

gregm784:
https://www.amazon.com/Rollmaster-0206-Harmonic-Balancer-Internal/dp/B0748JVH7W

opa1:
Thanks! I would have never thought of looking at amazon.

Navigation

[0] Message Index

[#] Next page