FEDs Forever!
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email
?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Home
Help
Calendar
Login
Register
FrontEngineDragsters.Org Forum
»
Technical
»
Roo Man's Room
(Moderator:
rooman
) »
Steering shaft
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Steering shaft (Read 2529 times)
sr1288
Newbie
Posts: 1
Your Best Time: 11.40
Your Engine: 327
Your Track: new england dragway
Your Vehicle: 1965 malibu ss
General Location: east coast of canada
Steering shaft
«
on:
June 05, 2018, 03:39:56 PM »
Hey, I am in the process of building a 180” fed. My question is regarding the steering shaft/rod length from the spindle to the frame or brack. Is there a specific length that these should be? Mine worked out to just under 8’, is this too long?
Logged
rooman
Moderator
Hero Member
Posts: 559
Your Best Time: 6.200/222.05 (1/4 mile--NT/F)
Re: Steering shaft
«
Reply #1 on:
June 07, 2018, 02:25:27 PM »
At anything over about 160" wheelbase I would normally use at least a 2 piece drag link. I usually run the front section at around four feet (or approximately as long as the radius rods if the car has a sprung front end).
Roo
Logged
Yeah, I am from the south--any further south and I would have been a bloody penguin.
Print
Pages: [
1
]
Go Up
« previous
next »
FrontEngineDragsters.Org Forum
»
Technical
»
Roo Man's Room
(Moderator:
rooman
) »
Steering shaft