« previous next »
Pages: [1]   Go Down

Author Topic: Steering shaft  (Read 2530 times)

Offline sr1288

  • Newbie
  • *
  • Posts: 1
    • View Profile
  • Your Best Time: 11.40
  • Your Engine: 327
  • Your Track: new england dragway
  • Your Vehicle: 1965 malibu ss
  • General Location: east coast of canada
Steering shaft
« on: June 05, 2018, 03:39:56 PM »
Hey, I am in the process of building a 180” fed. My question is regarding the steering shaft/rod length from the spindle to the frame or brack. Is there a specific length that these should be? Mine worked out to just under 8’, is this too long?
Logged

Offline rooman

  • Moderator
  • Hero Member
  • *****
  • Posts: 559
    • View Profile
  • Your Best Time: 6.200/222.05 (1/4 mile--NT/F)
Re: Steering shaft
« Reply #1 on: June 07, 2018, 02:25:27 PM »
At anything over about 160" wheelbase I would normally use at least a 2 piece drag link. I usually run the front section at around four feet (or approximately as long as the radius rods if the car has a sprung front end).

Roo
Logged
Yeah, I am from the south--any further south and I would have been a bloody penguin.
Pages: [1]   Go Up
« previous next »