« previous next »
Pages: [1]   Go Down

Author Topic: Helmet bar padding  (Read 2917 times)

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Helmet bar padding
« on: June 03, 2018, 08:09:55 AM »
 I was getting ready to buy some of the cheap pipe insulation style padding for helmet area and got to figuring up cost and replacement in cpl years.Then took a look at Garving motor sports stuff which is real close to ISP.Well excpet cost is about 1/3. Can not tell whole lot of difference in mine and the ISP stuff a buddies TA/D has. Well there is about 650 bucks difference 1100 vs 450(seat and head rest).

Give them a look before buying cheapy and not near protection stuff.http://www.garvinmotorsports.com/sitebuildercontent/sitebuilderpictures/Logo/GMSLOGO10m.gif
Logged
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline noslin

  • Sr. Member
  • ****
  • Posts: 259
    • View Profile
  • Your Best Time: 0.00
  • Your Engine: none
  • Your Track: none
  • Your Vehicle: none
  • General Location: west coast
Re: Helmet bar padding
« Reply #1 on: June 03, 2018, 11:13:09 AM »
i think ill get there seat insert kit.  seems like it would be easier to use.  pricing is great too.
Logged

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Helmet bar padding
« Reply #2 on: June 03, 2018, 04:31:14 PM »
Is not terrible to do but little bit of head ache. Takes a while,but you don't have to be on hand for all of it. Be sure to wear full suit when sitting in it to get as close as possible to what you want when finished.
Logged
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline rooman

  • Moderator
  • Hero Member
  • *****
  • Posts: 559
    • View Profile
  • Your Best Time: 6.200/222.05 (1/4 mile--NT/F)
Re: Helmet bar padding
« Reply #3 on: June 04, 2018, 04:22:33 AM »
This link may work a little better: http://www.garvinmotorsports.com/
 Jeff Garvin is a former fuel car crew guy so he has "been there and done that" at the top level of drag racing.

Roo
Logged
Yeah, I am from the south--any further south and I would have been a bloody penguin.
Pages: [1]   Go Up
« previous next »