« previous next »
Pages: [1]   Go Down

Author Topic: Cranking compression and nitro  (Read 2605 times)

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1110
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Cranking compression and nitro
« on: May 29, 2018, 01:27:51 PM »
Speaking about cranking compression I am wondering what others have with injected nitro ? I retarded my cam and went from 225 to 190 and the next step is to tighten up on my lash but I don't know what is too high or low !
Logged

Offline dusterdave173

  • Hero Member
  • *****
  • Posts: 638
    • View Profile
  • Your Best Time: 5.38in 1/8th
  • Your Engine: 355 CI SBC
  • Your Track: Mooresville, NC
  • Your Vehicle: CenPen 200 inch FED
Re: Cranking compression and nitro
« Reply #1 on: May 30, 2018, 03:13:11 AM »
I have run 20% with 225  my actual CR is about 13.7:1
My long term plan is build about an 11:1 short block with big cam and run around 50%
all of this vs. starting over with a blower
Logged
I have always had a fascination with fast cars at the expense of more normal character development

Offline msundstrom

  • Full Member
  • ***
  • Posts: 119
    • View Profile
  • Your Best Time: 7.45 @ 182 in 1/4
  • Your Engine: NA Injected 505 BBC on 45%
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: FED
  • General Location: Washington Coast
Re: Cranking compression and nitro
« Reply #2 on: May 30, 2018, 12:12:42 PM »
Intake valve closing point and static compression need to be considered together.
Logged
Pages: [1]   Go Up
« previous next »