« previous next »
Pages: [1]   Go Down

Author Topic: Tube removal  (Read 3855 times)

Offline opa1

  • Full Member
  • ***
  • Posts: 155
    • View Profile
  • Your Best Time: 5:60 1/8
  • Your Engine: 355 Chevy Methanol Injected
  • Your Track: Alamo City Motorplex
  • Your Vehicle: 71 Ed Mabry Jr. Fuel
  • General Location: South Coast
Tube removal
« on: March 30, 2018, 12:14:30 PM »
I have a Jr. Fuel car that had a mini battery just for the electronics. I'm needing to use a larger battery for self starting.There is a tube crossing the battery box. The tube was a add on by someone. You can see where the paint was removed to weld it in. Do you think the tube is needed? Can I remove it so a larger battery will fit?
Logged

Offline rooman

  • Moderator
  • Hero Member
  • *****
  • Posts: 559
    • View Profile
  • Your Best Time: 6.200/222.05 (1/4 mile--NT/F)
Re: Tube removal
« Reply #1 on: March 30, 2018, 01:56:43 PM »
Not sure why it was added--maybe some lateral stiffening of the chassis  but I can't see that it would cause major problems if you removed it.

Roo
Logged
Yeah, I am from the south--any further south and I would have been a bloody penguin.

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Tube removal
« Reply #2 on: March 30, 2018, 06:45:13 PM »
Agree on tube removal. Check Braile battry out small and stout cranking amp.Oh yea half the weight on nomal car sized battery.
Logged
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline opa1

  • Full Member
  • ***
  • Posts: 155
    • View Profile
  • Your Best Time: 5:60 1/8
  • Your Engine: 355 Chevy Methanol Injected
  • Your Track: Alamo City Motorplex
  • Your Vehicle: 71 Ed Mabry Jr. Fuel
  • General Location: South Coast
Re: Tube removal
« Reply #3 on: March 31, 2018, 08:48:05 AM »
Thanks, Those Braille batteries might fit without cutting the tube out. I'll have to do some measuring.
Logged

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1110
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: Tube removal
« Reply #4 on: April 01, 2018, 06:42:07 AM »
I run the small Braille in my car . part no B2317 weighs 17lbs
Logged
Pages: [1]   Go Up
« previous next »