« previous next »
Pages: [1]   Go Down

Author Topic: 25" PG Planetary  (Read 2887 times)

Offline opa1

  • Full Member
  • ***
  • Posts: 155
    • View Profile
  • Your Best Time: 5:60 1/8
  • Your Engine: 355 Chevy Methanol Injected
  • Your Track: Alamo City Motorplex
  • Your Vehicle: 71 Ed Mabry Jr. Fuel
  • General Location: South Coast
25" PG Planetary
« on: March 26, 2018, 07:03:09 PM »
I'm having to use a PG with the shorter 9" tailhousing in my FED. The output shaft is about 2" shorter that a standard length PG. The only planetary I have in that length is a 16 spline 1:76 from a early PG unit. Has anyone seen or heard of a planetary like this with 27 spline output shaft?

This is a older Jr. Fuel car. It had a PG with the 27 spline shorter shaft. It didn't come with the car.
Logged

Offline opa1

  • Full Member
  • ***
  • Posts: 155
    • View Profile
  • Your Best Time: 5:60 1/8
  • Your Engine: 355 Chevy Methanol Injected
  • Your Track: Alamo City Motorplex
  • Your Vehicle: 71 Ed Mabry Jr. Fuel
  • General Location: South Coast
Re: 25" PG Planetary
« Reply #1 on: March 27, 2018, 10:25:57 AM »
Problem solved. I can cut the std. length shaft. I'll still have about 1 3/4" of splines for the MW/1350 yoke to fit.
Logged

Offline racerken

  • Jr. Member
  • **
  • Posts: 52
    • View Profile
  • Your Best Time: 8.76 1/4 mile (FED)
  • Your Track: State Capital Raceway
  • Your Vehicle: FED
  • General Location: Baton Rouge La
Re: 25" PG Planetary
« Reply #2 on: March 27, 2018, 12:19:00 PM »
Done it before.  Just cut it to length with a hack saw.
Logged
Pages: [1]   Go Up
« previous next »