« previous next »
Pages: [1]   Go Down

Author Topic: Balancer Bolt Torque  (Read 3318 times)

Offline spitzerscott

  • Full Member
  • ***
  • Posts: 116
    • View Profile
    • Ogg Motorsports
  • Your Best Time: 5.73@118.80
  • Your Engine: 336 Small Block Chevy
  • Your Track: Osceola IN, Top Eliminator runs 1/8 mile
  • Your Vehicle: Spitzer225 RED, Alcohol SBC
  • General Location: Northern Indiana
Balancer Bolt Torque
« on: January 08, 2018, 03:13:02 PM »
What is the recommended torque spec for a 1/2-20 grade 8 balancer bolt, 1 inch thread engagement? Thanks,   Scott
Logged

Offline Frontenginedragsters

  • Full Member
  • ***
  • Posts: 202
    • View Profile
    • Pro-Formance Specialties
Re: Balancer Bolt Torque
« Reply #1 on: January 13, 2018, 02:48:21 PM »
Torque specs for that size bolt is 100Lbs.
Most harmonic balancers on Chevys hang out about .080" to .125" past the end of the crankshaft.
You will find in most cases the washer starts to dish inward. A thin washer inside to support the balancer washer helps.

Matt
Logged
Driving a Front Engine Dragster builds character and keeps you awake for a 1/4 mile at a time.
http://www.pro-formancespecialties.com/

Offline GlennLever

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2010
    • View Profile
    • The Lever Family Site
  • Your Best Time: 1/4 mile 7.950 at 165 MPH
  • Your Engine: Pontiac 461 Alky Blown
  • Your Track: Empire Dragway, NY
  • Your Vehicle: Front Engine Dragster
Re: Balancer Bolt Torque
« Reply #2 on: January 14, 2018, 05:41:42 PM »
Matt,

Thanks for your continued forum support.

Glenn
Logged
Glenn R. Lever
Rochester, New York 14617-2012
My Cars https://www.lever-family-racing.com/

Offline spitzerscott

  • Full Member
  • ***
  • Posts: 116
    • View Profile
    • Ogg Motorsports
  • Your Best Time: 5.73@118.80
  • Your Engine: 336 Small Block Chevy
  • Your Track: Osceola IN, Top Eliminator runs 1/8 mile
  • Your Vehicle: Spitzer225 RED, Alcohol SBC
  • General Location: Northern Indiana
Re: Balancer Bolt Torque
« Reply #3 on: January 15, 2018, 03:44:18 PM »
Thanks Matt, I talked to my local engine builder and got my answer.  Just thought more guys would chime in on that topic.
Logged
Pages: [1]   Go Up
« previous next »