Drag Racing Discussions > Front Engine Dragsters
New guy with cage questions
(1/1)
Guido:
Hello I'm 5'11" 210 lbs what size cage works be recommended? I see allot of 19" and 22" is that the inside bar measurement?
dreracecar:
Depends on the person measuring. Myself (as I build chassis's) measure the shoulder hoop at the tubing centerline where the bend starts. So when I say that the shoulder hoop is on 21" centers using 1.5" dia tubing, the inside width without the seat is 19.5".
Back in the day when drivers (back from war) were 138#, the suits were tin-foil, and the helmets were there to keep the hair out of your eyes, 19" (on center) was the standard, Now with bigger drivers, the SFI 15/20 suits and the larger helmets, along with a HANS, 21" (on center) has become the standard along with the shoulder hoop made from 2- 6" radius bends with a straight section between them verses the full radius bend an no straight. If you are big, try and avoid the "round back" chassis as it rolls/hunches your shoulders in/up too much and really confinds your movements and the Hans does not fit properly, A square back design allows your back to fit flat against the chassis/seat for more comfort and movement
Guido:
Thanks for the great info
dusterdave173:
Mine is 21 1/2 at the shoulder and I am 5' 11'' 235 and with 15 suit on I am comfortable
rooman:
I recently put a 6' 5"/280 lb driver in a 20" (inside dimension) shoulder hoop altered but I did have to put elbow pockets in the seat which is not really an option in a front motor dragster due to the placement of uprights to meet the SFI spec.
Roo
Navigation
[0] Message Index
Go to full version