Technical > Matt Shaff's Engine Shop

Engine is stiff, hard to turn over???

<< < (2/5) > >>

GlennLever:
The Crankshaft is broken, working on getting it out.

New one will have to be balanced. Hopefully the rod and piston weights were recorded.

If need be will pull # 8 rod and piston.

Problem may be the rod if it cannot be saved and new one needs to be ordered. Will also order the narrow bearings

 http://www.competitionproducts.com/Eagle-Forged-4340-Steel-Crankshaft-Pontiac-400-Main-4250-Stroke-6700-and-up-Rod-Length-2200-Journal/productinfo/EAG440042506700/#.WUm0Q_8YzFI.email

Supercat:
Ouch....
That's not as easy as a trans issue...

dreracecar:
And it did not break clean thru??

JrFuel Hayden:
Is that an OEM crank ?
Jon

Paul New:
That will cause it hard to turn! Your going to pull the engine apart to put a crank in it, it will be easy to measure the bob weight at that time of it wasn't recorded

Navigation

[0] Message Index

[#] Next page

[*] Previous page