Drag Racing Discussions > Drag Racing
HRR 2017
GlennLever:
--- Quote from: Paul New on June 22, 2017, 01:19:46 PM ---Has the machine shop looked at the block yet? If so is the main line ok?
--- End quote ---
I am just going to plastic-gauge the new bearings, and if they come up good will rebuild and test run the engine.
--- Quote from: dreracecar on June 22, 2017, 03:13:03 PM ---I was under the impression you put the alu block in
--- End quote ---
That e engine still is not complete, but close, pictures tomorrow maybe
Paul New:
--- Quote from: GlennLever on June 22, 2017, 07:34:03 PM ---
--- Quote from: Paul New on June 22, 2017, 01:19:46 PM ---Has the machine shop looked at the block yet? If so is the main line ok?
--- End quote ---
I am just going to plastic-gauge the new bearings, and if they come up good will rebuild and test run the engine.
--- End quote ---
I've never really had much faith in plastigage preferred putting a mic on things hope everything is ok with the block
DON:
Glenn,I can mic that up for you if you choose .I have all the proper tools to get the best accuracy .Let me know when and what you want to do.
Don
GlennLever:
--- Quote from: DON on June 23, 2017, 11:50:30 AM ---Glenn,I can mic that up for you if you choose .I have all the proper tools to get the best accuracy .Let me know when and what you want to do.
Don
--- End quote ---
The crankshaft came today and I made it out to Dan before he closed. He can cut the second key-way. Venoila is supposed to have the rods done Tuesday and I am overnighting them so they should be here Wednesday. I can get a rod and piston out to Dan and he can balance the crankshaft. When that is back in hand it will be time for assembly
Navigation
[0] Message Index
[*] Previous page
Go to full version