« previous next »
Pages: [1]   Go Down

Author Topic: hilborn 150-1 pump plumbing?  (Read 3208 times)

Offline crider

  • Full Member
  • ***
  • Posts: 206
    • View Profile
  • Your Best Time: 5.01
  • Your Engine: BBC
  • Your Track: farmington, Nc
  • Your Vehicle: in progress
  • General Location: south east
hilborn 150-1 pump plumbing?
« on: May 20, 2017, 04:24:51 AM »
What size feed line do I need for a -1 hilborn pump, feeding a BBC methanol with stack injection? Is a -10 big enough or does it need a -12 or something bigger?
Logged

dreracecar

  • Guest
Re: hilborn 150-1 pump plumbing?
« Reply #1 on: May 20, 2017, 08:59:40 AM »
On my Blown SBC with a 110 (13gal) from the pump to BV only ran a -8, do not want a pressure drop by going to a larger line. When I was running 410 sprints we used a -6 feed to the BV.
Logged

Offline crider

  • Full Member
  • ***
  • Posts: 206
    • View Profile
  • Your Best Time: 5.01
  • Your Engine: BBC
  • Your Track: farmington, Nc
  • Your Vehicle: in progress
  • General Location: south east
Re: hilborn 150-1 pump plumbing?
« Reply #2 on: May 20, 2017, 09:27:27 AM »
Thanks Bruce, my barrel valve had a -6 opening so I was going to use a -6 from the shutoff up to the injector. I should have been more specific, I was asking about the line from tank to pump
Logged

dreracecar

  • Guest
Re: hilborn 150-1 pump plumbing?
« Reply #3 on: May 20, 2017, 10:54:41 AM »
Inlet line to the pump   -12
Logged
Pages: [1]   Go Up
« previous next »