Author Topic: High speed location  (Read 3104 times)

Offline BK

  • Sr. Member
  • ****
  • Posts: 310
    • View Profile
  • Your Best Time: 8.45 / 5.30
  • Your Track: Empire Dagway
  • Your Vehicle: Late 70's FED
High speed location
« on: May 20, 2017, 04:55:40 AM »
 I just looked at two different schematics for plumbing a high speed lean out with an Enderle Cube and K style barrel valve.
 One shows it on the inlet side and the other shows it on the outlet side before the distribution block.
 I always thought inlet side was right but that doesn't mean it is.
 Is one preferred over the other?

 

Offline Spud Miller

  • Global Moderator
  • Sr. Member
  • *****
  • Posts: 332
    • View Profile
    • Fuel Injection Ent., LLC
Re: High speed location
« Reply #1 on: May 20, 2017, 08:27:20 AM »

 At WOT, there's no difference in operation in either spot. I like it ahead of the metering valve so it can help relieve pressure when the throttle is closed at high RPM. Also, on a blown setup, the fewer hoses going past the blower belt the better in my opinion.

 Spud

Fuel Injection Enterprises, LLC
     Mechanical Injection
     Magnetos
     EFI Conversions