Drag Racing Discussions > Front Engine Dragsters

P-S Enigneering parts needed

(1/2) > >>

buickfed:
just cleaned and painted the dragster for this year. found the king pin spindle bushings are worn. does anybody sell them? 

dreracecar:
Mark Williams sells a bushing kit just for the P&S spindles

buickfed:
thanks

buickfed:
I checked out their site. the parts were for later p-s's. lucky me I have an early version. did send them an email for further info. might have to make my own.

dreracecar:
P&S only made one version,  what is so different about yours????   Some dragster guys use to cut down the bushings flat to the top of the spindle to run solid flat arms and caps, and the heavier F/C ran the full bushings with holes in the arms. are they stamped P&S??  Rebushed many a P&S (old and new) when TAK (P&S) was around and they were all the same kit/bushings

Navigation

[0] Message Index

[#] Next page