Technical > Roo Man's Room
Anti-Rotation Bracket Ideas - 57-64 Olds
dwrfab:
I hope you are going to weld a tube in front of the mount plates. They need to be welded completely on one side and skip welded 1" skip welds on the other.
crider:
Kinda looks like you have the whole drivetrain mounted too low in the chassis?
Countn Carbs:
--- Quote from: dwrfab on February 26, 2017, 04:31:33 PM ---I hope you are going to weld a tube in front of the mount plates. They need to be welded completely on one side and skip welded 1" skip welds on the other.
--- End quote ---
Yeah sorry - I should have clarified this and thank you for the advice. I still have to fit/cope them but the plan is for 1.500 O.D vertical tubes (.125" wall) with the mounting plates then welded like you described. I just tacked this in to see what I was going to do for anti-rotation set up.
rooman:
--- Quote from: crider on February 26, 2017, 05:24:40 PM ---Kinda looks like you have the whole drivetrain mounted too low in the chassis?
--- End quote ---
I agree. As it sits now it appears that you will have something like 9" or 10" of ground clearance with any sort of reasonable tire diameter.
Roo
janjon:
What will the kidney bars look like?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version