« previous next »
Pages: 1 [2]   Go Down

Author Topic: Diaper or belly pan  (Read 10911 times)

Offline tinbanger

  • Newbie
  • *
  • Posts: 28
    • View Profile
    • William
  • Your Best Time: 7.85
  • Your Track: Lebanon Valley
  • Your Vehicle: 225" Spitzer FED
Re: Diaper or belly pan
« Reply #15 on: April 03, 2017, 08:02:42 AM »
I got 4 $2.00 clip boards at staples. Removed the clips and riveted the int my pan. Looks trick and works .
Logged

Offline THE FRENCHTOWN FLYER

  • Sr. Member
  • ****
  • Posts: 360
    • View Profile
  • Your Best Time: 8.28@168 door; 9.00@147 6-cyl alt; 8.53@160 RED
  • Your Engine: 300 Ford six NA w/ crossflow and prod. heads
  • Your Track: Milan, Thompson
  • Your Vehicle: (3) Advanced Chassis altered , The Last Logghe altered, '30 RPU
  • General Location: North Coast
Re: Diaper or belly pan
« Reply #16 on: May 15, 2017, 08:46:26 AM »
That is kinda what I use on my personal car - metal straps Dzused inplace over Pig Mats. I also have one on my belly pan under the transmission. I have also seen metal mesh screen used to retain the pads.

I am a part-time tech inspector at the once-a-month Heads Up series at our local NHRA track where diapers or pans are mandatory on ALL classes. I have been asking some of the top competitors which they prefer - diaper or pan? I'd say it runs about 60/40 pans to diapers.
Logged

Offline buickfed

  • Full Member
  • ***
  • Posts: 191
    • View Profile
Re: Diaper or belly pan
« Reply #17 on: May 15, 2017, 03:46:25 PM »
I looked at doing a pan, but the oil pan sits below the bottom rail and I don't another something dragging against the trailer when loading it. now that said, I went and bought a 'will fit' one. well, it just don't fit my engine because I run a 350 buick.  as usual i have to find someone to make one.  :'( :'(
Logged
Pages: 1 [2]   Go Up
« previous next »