« previous next »
Pages: [1]   Go Down

Author Topic: Max hp with 1.82 gear set?  (Read 4421 times)

Offline Mister_Fitz

  • Newbie
  • *
  • Posts: 40
    • View Profile
  • Your Track: Trackless
  • Your Vehicle: FED
Max hp with 1.82 gear set?
« on: September 19, 2016, 12:24:26 PM »
I'm running a FED with a 350" sbc and a shorty PG.
The planetary is a standard stampeld steel with 1.82 helical gears. FED is about 1400 punds. Best 60' is 1.21 sec. Best 1/4 is 8.26 sec.
How much more will it take? Is it time to change to a straight cut gear set?
Logged

Offline masracingtd1167

  • Hero Member
  • *****
  • Posts: 1110
  • bill masiello Shelton Ct.
    • View Profile
  • Your Best Time: 7.40's at 181 on motor 6.94 at 192 nitrous
  • Your Engine: 394 chevy
  • Your Track: Lebanon Valley Dragway
  • Your Vehicle: 2003 Neil and Parks
Re: Max hp with 1.82 gear set?
« Reply #1 on: September 19, 2016, 01:58:15 PM »
I honestly think you are just about there . Some of the Comp guys run that carrier with the straight cut gears because it is lighter than the the 1.76 carrier . I just switched mine over from the 1.80 to a 1.69 low and the car seems to like it a little better .
Logged

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: Max hp with 1.82 gear set?
« Reply #2 on: September 19, 2016, 06:40:21 PM »
I agree I think you are pushing the limits of a 1.82. I have changed customers from 1.82 to a 1.76 with little or no difference in 60ft times. For no more that it would cost to switch I would make the move if/when you break the 1.82
Logged

Offline THE FRENCHTOWN FLYER

  • Sr. Member
  • ****
  • Posts: 360
    • View Profile
  • Your Best Time: 8.28@168 door; 9.00@147 6-cyl alt; 8.53@160 RED
  • Your Engine: 300 Ford six NA w/ crossflow and prod. heads
  • Your Track: Milan, Thompson
  • Your Vehicle: (3) Advanced Chassis altered , The Last Logghe altered, '30 RPU
  • General Location: North Coast
Re: Max hp with 1.82 gear set?
« Reply #3 on: February 27, 2017, 05:17:38 PM »
In my six cylinder S/P altered (1.19 sixty, 5.60, 9.00) I saw little performance difference in the 1.82 vs 1.76 ratios. But 1.82s are easily obtainable cheap. I TIG the ends of the six planetary spud shafts to the case with bronze rod to significantly increase the rigidity of the assembly.
Logged
Pages: [1]   Go Up
« previous next »