Technical > Matt Shaff's Engine Shop

Shaft mount rockers SBC

<< < (2/2)

dusterdave173:
That is the exact point I was making
And --T&D quality is just fine but I have found over the years that Jesel ships product fast no BS'ing around--as a builder I can't stand to wait on slow delivery--T&D has left us waiting especially when you need a single replacement etc
wait until you get a set of dream heads then go shaft and never look back

Mister_Fitz:
You might be right. Shaft mount rockers are a to big investment in these heads.
I have been running 3/8" rocker arm studs with a girdle for some years with out any problems. Spring pressure is around 550 lbs and lift is around .710"
Will this still work with .150" stud mounted offset rockers?

jeff/21:
why wouldn't work if it's just the rocker that's offset i have also run girdles with both 3/8" and 7/16" with little or no problem on a sbc also ran TD and didn't have trouble getting parts and Jesel on bbc it was just a question of getting the right parts as aftermarket heads specs vary even with the same brand

Navigation

[0] Message Index

[*] Previous page