Drag Racing Discussions > Front Engine Dragsters

Spiral Morse Cables ?

(1/2) > >>

PSweeney:
Where can I get these to length ?

rooman:
You can order them through Jim and his gang at Good Vibrations (http://www.goodvibesracing.com/) or go direct to the source at Control Cables (http://www.controlcables.com/). Murf McKinny also carries them in even foot (and six inch) increments (http://www.mckinneycorp.com/). Both Good Vibes and McKinney are also used to shipping overseas.

Roo

glofria:
We've always had good luck withe these folks, but can't say if they will sell to an overseas consumer: http://www.power-trans.net/

Good luck.

PSweeney:

--- Quote from: rooman on November 14, 2016, 05:27:14 AM ---You can order them through Jim and his gang at Good Vibrations (http://www.goodvibesracing.com/) or go direct to the source at Control Cables (http://www.controlcables.com/). Murf McKinny also carries them in even foot (and six inch) increments (http://www.mckinneycorp.com/). Both Good Vibes and McKinney are also used to shipping overseas.

Roo

--- End quote ---

Thanks Roo, are these the low resistance, super bendy ones you can virtually tie a knot in ?

PSweeney:

--- Quote from: glofria on November 14, 2016, 05:28:07 PM ---We've always had good luck withe these folks, but can't say if they will sell to an overseas consumer: http://www.power-trans.net/

Good luck.

--- End quote ---

Thanks will check them out

Navigation

[0] Message Index

[#] Next page