Author Topic: TCI TRANSBARKE QUESTION--GASKETS  (Read 4019 times)

Offline dusterdave173

  • Hero Member
  • *****
  • Posts: 638
    • View Profile
  • Your Best Time: 5.38in 1/8th
  • Your Engine: 355 CI SBC
  • Your Track: Mooresville, NC
  • Your Vehicle: CenPen 200 inch FED
TCI TRANSBARKE QUESTION--GASKETS
« on: October 14, 2016, 10:55:52 AM »
Dan
I am gathering parts for a spare race glide--I got a nice older TCI brake--sportsman style in great shape as guy wanted Pro brake--question: does it use special valve body gaskets or can I use ones in std kit--I have plenty of std gaskets--did not want to order if I did not need --it had been run without any so no older ones to go by  Thanks!!!!
I have always had a fascination with fast cars at the expense of more normal character development

Offline BK

  • Sr. Member
  • ****
  • Posts: 310
    • View Profile
  • Your Best Time: 8.45 / 5.30
  • Your Track: Empire Dagway
  • Your Vehicle: Late 70's FED
Re: TCI TRANSBARKE QUESTION--GASKETS
« Reply #1 on: October 14, 2016, 06:36:28 PM »
I had a similar problem with a valve body. I was told to make sure there was an openings in the gasket for every openings in the separator plate. Extra holes are OK as long as they cant bleed into others. Followed those instructions and it worked out fine.

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: TCI TRANSBARKE QUESTION--GASKETS
« Reply #2 on: October 16, 2016, 08:31:42 PM »
Rule of thumb is "if it is a steel seperator plate, gaskets are a must, if it aluminum they are not needed. If you do use gaskets the above info is spot on! I do not use gaskets in the valvebodies I build.

Offline dusterdave173

  • Hero Member
  • *****
  • Posts: 638
    • View Profile
  • Your Best Time: 5.38in 1/8th
  • Your Engine: 355 CI SBC
  • Your Track: Mooresville, NC
  • Your Vehicle: CenPen 200 inch FED
Re: TCI TRANSBARKE QUESTION--GASKETS
« Reply #3 on: October 17, 2016, 04:39:17 AM »
aluminum so I am good Thanks!
I have always had a fascination with fast cars at the expense of more normal character development

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: TCI TRANSBARKE QUESTION--GASKETS
« Reply #4 on: October 17, 2016, 05:22:29 PM »
An explanation as to why no gaskets are needed with aluminum. The softer aluminum will compress when the valve body is tightened, conforming to the slight irregularities in the casting surface. Steel just does not do this.