Technical > Dan Dishon's Transmission Den
Another Powerglide question
Ponti:
--- Quote from: Paul New on June 06, 2016, 08:34:53 AM ---I only know TCI builds this
http://www.jegs.com/i/TCI/890/744409/10002/-1
not sure if it will work with a transbrake or shorty kit
--- End quote ---
--- Quote from: jeff/21 on June 07, 2016, 04:14:24 PM ---With the the kit for the circle-glide you don't need a rear pump it engages the low band
--- End quote ---
Have either of you got instructions for fitting this? Used one or know how they work in the way of plumbing.
Paul New:
[/quote]
The distance I have is 86cm from the rear of the motor plate to the front of the axle case, I don't have the front of the 9" so I don't know its length.
[/quote]
33.85" + 1.5" for the axle diameter= 35.35" CL of axle to mid plate. Off of the TCI website it says a shorty glide is 19.5"
bikeguy307:
You can get the instructions for the TCI kit off their web site. Should be a pdf download. It basically works like a hydraulic clutch you will need a master cylinder and lever/pedal to apply the band. The corse spline short glide is 26" long. Not sure if you have room for that. Or if you could get a coupler with the corse spline.
jeff/21:
bikeguy is right you need a master cylinder and the servo acts as the slave
Ponti:
Thanks guys. I have dropped the shell of the box in the car and measured it. Hope the attached pictures make more sense of the space and distance left between rear of box and front of axle casing.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version