« previous next »
Pages: [1]   Go Down

Author Topic: converter to crank alignment  (Read 3396 times)

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
converter to crank alignment
« on: June 14, 2016, 07:23:47 PM »
Long story short. I machined a adapter midplate for lil brothers new project.A VW vr-6 turbo eninge to powerglide transmission.Lots of hours and cpl bags of chips.
Seems  I have trans about .015 high. going to make inserts  and drill to hopefully get dead on.

I know .0000 would be ideal,but in real world? How much tolerance is there in alignment?
Logged
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot

Offline jeff/21

  • Full Member
  • ***
  • Posts: 186
    • View Profile
  • Your Best Time: 8.24
  • Your Track: any with-in a 6hr radius
  • Your Vehicle: fed
Re: converter to crank alignment
« Reply #1 on: June 15, 2016, 04:15:57 PM »
why not use offset dowel pins?
Logged

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: converter to crank alignment
« Reply #2 on: June 19, 2016, 04:00:16 PM »
I dont know but I think I would do what ever it took to be .000.
Logged
Pages: [1]   Go Up
« previous next »