« previous next »
Pages: [1]   Go Down

Author Topic: PG Pump Question  (Read 3933 times)

Offline dusterdave173

  • Hero Member
  • *****
  • Posts: 638
    • View Profile
  • Your Best Time: 5.38in 1/8th
  • Your Engine: 355 CI SBC
  • Your Track: Mooresville, NC
  • Your Vehicle: CenPen 200 inch FED
PG Pump Question
« on: May 10, 2016, 12:08:00 PM »
I am building another Powerglide tomorrow  I purchased a pump that had been machined, new gears etc looks nice--it has a bushing for Turbo shaft in the tube  QUESTION  I will be running a PG spline converter and an aftermarket shaft with std PG spline so does that bushing have to come out or can it stay?
Thanks!!
Logged
I have always had a fascination with fast cars at the expense of more normal character development

Offline msundstrom

  • Full Member
  • ***
  • Posts: 119
    • View Profile
  • Your Best Time: 7.45 @ 182 in 1/4
  • Your Engine: NA Injected 505 BBC on 45%
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: FED
  • General Location: Washington Coast
Re: PG Pump Question
« Reply #1 on: May 10, 2016, 03:32:19 PM »
I run the same thing with the bushing in. No problems here.
Mark
Logged

Offline dusterdave173

  • Hero Member
  • *****
  • Posts: 638
    • View Profile
  • Your Best Time: 5.38in 1/8th
  • Your Engine: 355 CI SBC
  • Your Track: Mooresville, NC
  • Your Vehicle: CenPen 200 inch FED
Re: PG Pump Question
« Reply #2 on: May 10, 2016, 03:45:34 PM »
Thanks!!!!!!!!!!!!!!!!!!!!!
Logged
I have always had a fascination with fast cars at the expense of more normal character development

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: PG Pump Question
« Reply #3 on: May 10, 2016, 08:16:34 PM »
Leave the bushing in, it will cause no problems, and if you ever need to swap out to a turbo spline shaft and converter you will be ready.
Logged
Pages: [1]   Go Up
« previous next »