Drag Racing Discussions > Front Engine Dragsters
What constitutes a "securely mounted" seat pan in a FED?
tcoupekyle:
Dreracecar, what about the tube position? Does more tubing need to be ran under the seat? I read 2.4b spec on it but, I didn't understand it.
dreracecar:
Has the chassis ever been certed before to 2.4 spec. by NHRA ?
What did you not understand about the spec?
Really hard to make an assesment just by that pic alone---eveything is covered up
tcoupekyle:
It had nhra cert to 7.49 or slower I think that is 2.6 spec? Not really trying to go faster than that. I just had access to the 2.4 spec when I was working on it yesterday.
The question I have is does the seat need to be supported in the back by tubing?
tcoupekyle:
I'm changing the seat cause, with the seat that was in it when I bought the car I can't reach the pedals.
tcoupekyle:
Where the recline in the seat is there's nothing there the other seat went flat.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version