Author Topic: S&W Chassis Kit  (Read 4827 times)

Offline bigblockrik

  • Newbie
  • *
  • Posts: 7
    • View Profile
  • Your Track: edgewater
  • Your Vehicle: fed
S&W Chassis Kit
« on: March 20, 2016, 04:51:57 PM »
Well the tight azz in me is wondering if if would benefit buying a kit from them or buying a blueprint.I have a tubing bender would have to get a new die for it.Are they a stepped rail or one size.Also in the kits are all the notches done.I had another post but it is gone.Thanks In advance Eric

Offline PSweeney

  • Full Member
  • ***
  • Posts: 231
    • View Profile
  • Your Track: Santa Pod
  • Your Vehicle: 138in SBC slingshot
Re: S&W Chassis Kit
« Reply #1 on: March 25, 2016, 03:35:23 AM »
If you have a bender do it yourself. Plenty of people on here to advise you on dimensions, but go buy the sfi specs and you'll figure the rest out as you go.

dreracecar

  • Guest
Re: S&W Chassis Kit
« Reply #2 on: March 25, 2016, 08:03:34 AM »
Its not just the kit but everything else that one needs to assemble the kit. You are going to need fixtures and line-up bars to get the motor square to the rear end. Also if you have never welded a 180" car before made out of thin Moly, you are in for a big suprise

Offline bigblockrik

  • Newbie
  • *
  • Posts: 7
    • View Profile
  • Your Track: edgewater
  • Your Vehicle: fed
Re: S&W Chassis Kit
« Reply #3 on: March 26, 2016, 09:23:46 AM »
Well i have never welded any moly yet.Going to make a table to assemble it on i have one that i build cars on but it is too wide for one of these.As for a line up bar i will make one of them also.