S&W Chassis Kit

[bigblockrik]

Well the tight azz in me is wondering if if would benefit buying a kit from them or buying a blueprint.I have a tubing bender would have to get a new die for it.Are they a stepped rail or one size.Also in the kits are all the notches done.I had another post but it is gone.Thanks In advance Eric

[PSweeney]

If you have a bender do it yourself. Plenty of people on here to advise you on dimensions, but go buy the sfi specs and you'll figure the rest out as you go.

[dreracecar]

Its not just the kit but everything else that one needs to assemble the kit. You are going to need fixtures and line-up bars to get the motor square to the rear end. Also if you have never welded a 180" car before made out of thin Moly, you are in for a big suprise

[bigblockrik]

Well i have never welded any moly yet.Going to make a table to assemble it on i have one that i build cars on but it is too wide for one of these.As for a line up bar i will make one of them also.