Author Topic: Direct drive  (Read 12854 times)

Ponti

  • Guest
Re: Direct drive
« Reply #15 on: February 16, 2016, 09:06:14 AM »
Thanks guys, will keep my eyes open. Looking at the picture of the Lenco reverser, how do you fit it direct to a bellhousing.

Offline sknopp

  • Newbie
  • *
  • Posts: 41
    • View Profile
  • Your Best Time: 7.008@215 on 7.00 Index
  • Your Track: Bowling Green
  • Your Vehicle: 1969 MW 214" FED
Re: Direct drive
« Reply #16 on: February 16, 2016, 09:48:15 AM »
To mount that reverser you need to make an adapter plate.  There are also reverse units that bolt directly to the bell housing.

Does the facility where you will race mandate a reverser?  If not, you could run without one.  Just burn our behind the line, or have a couple buddies push you back.

Steve K.

Ponti

  • Guest
Re: Direct drive
« Reply #17 on: February 16, 2016, 01:10:24 PM »
Problem I have is I don't have a large crew, will normally only be just 2 of us so the reverser will just make life easier if I roll over the line.