Drag Racing Discussions > Front Engine Dragsters

wires etc from driver to front

(1/3) > >>

probird:
Hello Fedders!
Progress is coming along good. I'm waiting for my welder to get back from up north. In the mean time I'm trying to figure out routing of the wiring and cables. When I received my car, the wiring and cables were run beside the midplate. can I do this again?
One main power for the cab compartment, power shutoff cable, coil wires to the dist., throttle cable and a few small wires for relays in front.
Thanks
Barry

rooman:
Baz,
      I is a little difficult to do in a retrofit situation but I put sleeves in the motor uprights for cables, electrical. fire bottle lines.

Roo

wideopen231:
I did mine as Rooman stated.I did not do enough and had to add more.Step drill and 90* drill are your friends here.Problem is not so much welding them in as drilling them,I used 3/4" tubing to allow room for multiple wires in one and for cables.

probird:
Ok. Looks like I'll go pick up a step drill today.
Thanks guys!

grapro:
Barry
I have lots of step drills

Navigation

[0] Message Index

[#] Next page