Technical > Dan Dishon's Transmission Den

leaking sealat shift shaft

<< < (2/2)

msundstrom:
I considered that and checked the torque to shift in and out of park and gear to gear and had between 7 and 18 ft.lbs then cut a .040" o-ring groove in a shift shaft and held to 160 ft.lbs so I felt pretty safe . Probably won't work on a stock hollow shaft.
Mark S

bikeguy307:
Thanks, Mark. That's great info, and glad you did the research before just cutting into the shaft.

Navigation

[0] Message Index

[*] Previous page