« previous next »
Pages: [1]   Go Down

Author Topic: Pump feed line  (Read 3656 times)

Offline msundstrom

  • Full Member
  • ***
  • Posts: 119
    • View Profile
  • Your Best Time: 7.45 @ 182 in 1/4
  • Your Engine: NA Injected 505 BBC on 45%
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: FED
  • General Location: Washington Coast
Pump feed line
« on: December 13, 2015, 09:29:51 AM »
Hi Spud,
If you had a 6 GPM pump and fed it with a -10 line vs. a -12 line is there any advantage or disadvantage to ultimate pump output?
Thanks
Mark S
Logged

Offline Spud Miller

  • Global Moderator
  • Sr. Member
  • *****
  • Posts: 332
    • View Profile
    • Fuel Injection Ent., LLC
Re: Pump feed line
« Reply #1 on: December 14, 2015, 08:59:13 AM »

 As long as everything is optimal (gravity fed, etc.) then you'll be ok. If it has to draw far or there's a funky 90 degree fitting in there or something like that you might have trouble. -10 is the smallest I'd ever use on a 6 GPM pump.

 Spud
Logged

Fuel Injection Enterprises, LLC
     Mechanical Injection
     Magnetos
     EFI Conversions

Offline alkyal

  • Jr. Member
  • **
  • Posts: 52
    • View Profile
  • Your Track: Quaker City/Dragway 42
  • Your Vehicle: Not a Driver-Nostaliga AA/FD
Re: Pump feed line
« Reply #2 on: December 15, 2015, 03:30:34 PM »
I have been looking @ the inlet size also. What good is a a -12 or -16 line if the fitting that screws into the PUMP is only a -8. I understand that a 6 gpm pump would not present a problem, however I can speak from experience that a 7 gpm pump with the -8 threaded inlet is on the edge with alky.
Logged

Offline Van

  • Full Member
  • ***
  • Posts: 116
    • View Profile
  • Your Best Time: 7.11 @ 189 with this car
  • Your Engine: Lincoln blown alky 534
  • Your Track: Bakersfield Ca.
  • Your Vehicle: Dragster
  • General Location: west coast
Re: Pump feed line
« Reply #3 on: December 15, 2015, 07:33:56 PM »
Hilborn & Enderle  supply a PORTED inlet fitting, usually steel and is bored to  thin +  and flow's far more than a -8 std fitting.
« Last Edit: December 15, 2015, 07:36:44 PM by Van »
Logged

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Pump feed line
« Reply #4 on: December 16, 2015, 01:31:14 PM »
Heck I have 1" line and feel its small and thats with large radius sweeping 90.
Logged
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot
Pages: [1]   Go Up
« previous next »