Drag Racing Discussions > Front Engine Dragsters
new fed to me questions
probird:
Agree. Do it once and be done. Thanks for the tips! My winter project is to make sure it's good.
slingshot383:
A dragster/ funny car pan doesn't set as deep, but runs the length of the engine. I wouldn't push the engine back, but I would set it at the height you want it (as long as that is level to a 2* nose down off parallel with your surface table.
wideopen231:
If its was me.I would rework mounts for rear end and raise motor and make new plates.You get everything into lot better etuo and very little expence.
George:
Sorry but I have to ask. Was this chassis with current certification ?
probird:
Yeah. That's why I asked if 2.6a specs is a little different. It was done this year. Nhra. Down in North Dakota.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version