Drag Racing Discussions > Front Engine Dragsters

Coupler questions

(1/4) > >>

tcoupekyle:
We mocked up the motor and trans in my dragster.  Now I'm completely lost on what to do about a Coupler. Running a shorty glide and a 9 inch the nine inch had the female side on it but I'm roughly 14 inches from the glide output to the 9 inch input.  Somebody school me on what to do,  please.

ricci32:
Take a look at the mark Williams web site they have a driveshaft coupler that will work.

dreracecar:
1 - male coupler to PG out-put #40800
1 -female coupler  X 32 or 16 spline #40640
1- male coupler  X 32 or 16 spline #40780
1- correct length drive shaft  x 32 0r 16 spline #41050 (XX)
2- 1 3/8" collars (get these for McMaster, $9 VS $31 ea)
4 - nice crisp $100 bills

one of the reasons I went with a full length PG, just had to buy a coupler for the trans

tcoupekyle:
Thank ya'll very very much

wideopen231:
Good news.Since your driveshaft will be around 12" it will be 135 not the 210 my 19" cost.Just placed order Monday,I was luky that I had the femaile couplers.Oh yea coupler for trans is 85 bucks also.

Navigation

[0] Message Index

[#] Next page