Technical > Roo Man's Room

Engine mount

(1/1)

JeffV8:
Should I mount my 331 hemi with solid mounts or use a rubber mount like the speedway set up??

Thanks

rooman:
If you are putting it in a street car a cush mount is the go but for racing (with a tube chassis car) just put a saddle on the top rails that ties to the lugs on the block. The factory mount holes are large so I usually make a "top hat" bush to sleeve them down to 3/8" to match the most common tabs. You can also run front mount plates off the water pump holes, again to saddles and tabs on the top rail.

Roo

JeffV8:
Thanks Roo, my car has a square tube chassis ,the engine is blown and injected and has a Doug Nash 4+1 tranny. It will more than likely a street car. Some racing.

Navigation

[0] Message Index