Drag Racing Discussions > Front Engine Dragsters
Front Spindles
Racing6:
My car has home made spindles and I need front wheels. I have found some spindles but don't know how to ID them I can stay with original or use new, just don't what I have
dreracecar:
Hold them up to the computer screen so that someone might be able to ID them.
Seriously---If you want something ID'd YOU HAVE TO POST PICTURES!!!!!
JrFuel Hayden:
Also measure the spindle length, & inner [ closest to the king pin] bearing area OD and outer [ cotter-pin/ nut] bearing OD, and post them or Email me jchansen60@gmail.com, I no doubt will have wheels for you, or can make something.
Jon Hansen, Hayden Wheels, 800-624-3803
Racing6:
Sorry about Pictures, I was asking how to ID them But good point will get instruction from my grandkid tonight on how to up load a picture and post it tomorrow. Jon shaft length is 3.46 inch, Large bearing is .99 inch,small bearing .626 These are from spindle I found. Will get measurements of original tonight Thanks will e-mail you to get prices of wheels
dreracecar:
Inner should be 25mm and the outer .625 for it to be considered an Anglia type. Very common, and still quite prevalent today. kingpin dia shoud be close to 11/16
Navigation
[0] Message Index
[#] Next page
Go to full version