Front Spindles

[Racing6]

My car has home made spindles and I need front wheels. I have found some spindles but don't know how to ID them I can stay with original or use new, just don't what I have   

[dreracecar]

Hold them up to the computer screen so that someone might be able to ID them.

Seriously---If you want something ID'd   YOU HAVE TO POST PICTURES!!!!!

[JrFuel Hayden]

Also measure the spindle length, &  inner [ closest to the king pin] bearing area OD and outer [ cotter-pin/ nut] bearing OD, and post them or Email me jchansen60@gmail.com,  I no doubt will have wheels for you, or can make something.

Jon Hansen, Hayden Wheels, 800-624-3803

[Racing6]

Sorry about Pictures, I was asking how to ID them  But good point will get instruction from my grandkid tonight on how to up load a picture and post it tomorrow. Jon shaft length is 3.46 inch, Large bearing is .99 inch,small bearing .626 These are from spindle I found. Will get measurements of original tonight Thanks will e-mail you to get prices of wheels

[dreracecar]

Inner should be 25mm and the outer .625 for it to be considered an Anglia type. Very common, and still quite prevalent today.  kingpin dia shoud be close to 11/16

[Racing6]

Thank You those are the sizes

[JrFuel Hayden]

Yes, Bruce is right you have Anglia type spindles,
let me know if you want wheels, if cost is an issue, call me I have some trade-ins/ close-outs for sale.

Jon, Haydenent.com, 805-444-4489