Author Topic: Axle removal 8 3/4"  (Read 3746 times)

Offline gasserx

  • Full Member
  • ***
  • Posts: 192
    • View Profile
  • Your Best Time: 1/4 - 9.08
  • Your Track: Gardermoen Raceway
  • Your Vehicle: 180" FED
Axle removal 8 3/4"
« on: January 02, 2015, 06:54:58 AM »
I need to remove the axles to be able to drill some extra holes for the housings chassis mount.
I havent played around with these axles/housings before at all, so i was just wondering if i need a special tool to pull them out before i start, and if i need to replace bearing, gaskets etc before putting it together?

dreracecar

  • Guest
Re: Axle removal 8 3/4"
« Reply #1 on: January 02, 2015, 08:46:12 AM »
Most of the time the rears are set up with Olds bearing ends because of the rather large bearing size so its just the removal of the 4 retainer bolts  and a deadblow hammer

Offline gasserx

  • Full Member
  • ***
  • Posts: 192
    • View Profile
  • Your Best Time: 1/4 - 9.08
  • Your Track: Gardermoen Raceway
  • Your Vehicle: 180" FED
Re: Axle removal 8 3/4"
« Reply #2 on: January 02, 2015, 10:03:56 AM »
Thanks dre  :)