Drag Racing Discussions > Front Engine Dragsters

9 inch center section?

<< < (2/2)

masracingtd1167:
If you use the Strange Alluminum carrier with 3/8 bolts make sure your bolts or studs are long enough to go all the way in . When  you use things like a pinion support or coupler cover bolted to the pinion support you need a longer bolt or stud . I found this out the hard way and toe the pinion support right out of mine ! It was a stupid mistake to make and I thought I would pass this along .As far as the gasket try your center section with and without the gasket and see how your axles go in . On my housing my axles bind a little with a gasket and not at all without so I just use silicone on mine but it is something you should check .   

Navigation

[0] Message Index

[*] Previous page