Technical > Roo Man's Room
Axle removal 8 3/4"
(1/1)
gasserx:
I need to remove the axles to be able to drill some extra holes for the housings chassis mount.
I havent played around with these axles/housings before at all, so i was just wondering if i need a special tool to pull them out before i start, and if i need to replace bearing, gaskets etc before putting it together?
dreracecar:
Most of the time the rears are set up with Olds bearing ends because of the rather large bearing size so its just the removal of the 4 retainer bolts and a deadblow hammer
gasserx:
Thanks dre :)
Navigation
[0] Message Index
Go to full version