Technical > Dan Dishon's Transmission Den

Front Pump Question

(1/1)

dusterdave173:
Dan--One more!
I have fresh new pump for PG  --has new stator tube , new gears etc drilled out but..it still has stock style priming valve with roll pin--should I thread that hole and elimate the priming valve like FTI says? They show flipping the valve, tossing spring and using 1/4 pipe plug thus eliminating the valves operation--or in my case just leave it alone?
Thanks so much for the time you have been putting in on here for us!

bikeguy307:
I have never had an issue leaving the valve as is. Replace the stock roll pin with a new heavier one. this valve only needs modified when your making big line pressure.

Navigation

[0] Message Index