« previous next »
Pages: [1]   Go Down

Author Topic: Front Pump Question  (Read 3895 times)

Offline dusterdave173

  • Hero Member
  • *****
  • Posts: 638
    • View Profile
  • Your Best Time: 5.38in 1/8th
  • Your Engine: 355 CI SBC
  • Your Track: Mooresville, NC
  • Your Vehicle: CenPen 200 inch FED
Front Pump Question
« on: December 22, 2014, 10:26:42 AM »
Dan--One more!
I have fresh new pump for PG  --has new stator tube , new gears etc drilled out but..it still has stock style priming valve with roll pin--should I thread that hole and elimate the priming valve like FTI says? They show flipping the valve, tossing spring and using 1/4 pipe plug thus eliminating the valves operation--or in my case just leave it alone?
Thanks so much for the time you have been putting in on here for us!
Logged
I have always had a fascination with fast cars at the expense of more normal character development

Offline bikeguy307

  • Full Member
  • ***
  • Posts: 241
    • View Profile
Re: Front Pump Question
« Reply #1 on: December 22, 2014, 05:46:45 PM »
I have never had an issue leaving the valve as is. Replace the stock roll pin with a new heavier one. this valve only needs modified when your making big line pressure.
Logged
Pages: [1]   Go Up
« previous next »