Technical > Dan Dishon's Transmission Den

Powerglide Vent

(1/2) > >>

jspell:
Hi Dan,
My glide is a stock case glide with upgraded internals, my question is it has the stock plastic type vent cap, I see a lot of racers have a line in this location hooked to a tank?  should I go with that setup?

Thanks,
John

bikeguy307:
To the best of my knowledge NHRA is now requiring vents be ran to a catch can. The vent hole in the case is the right size to be tapped 1/8pipe. Most just use brass fittings and 1/4 plastic air line to do the vent to can process.

Hope this helps, Dan 

jspell:
Thanks Dan, great forum.

bikeguy307:
Thanks! I'm going to do my best!

Dan

spitzerscott:
Dan, can that be tapped with the tranny assembled or do you need to gut the case?

Navigation

[0] Message Index

[#] Next page